Materials for moulds and jigs

Composite floorboards (other ideas are possible) and wood glue

Sand paper, wax polish

(Polyurethane varnish, and PVA release agent, if available.)

Paint brushes, and thinners to clean them

1 3mm Plywood for jigs and formers and stator mould centre

Steel rod, or pipe, for coil winding machine

Small pieces of steel plate or thick sheet metal

Bolts (with nuts and washers)	diameter	length	For
2 with butterfly nuts	6mm	60mm	coil winder
4	1 0mm	25mm	balancing with jig
1	12mm	1 50mm	stator mould

Tools

Safety goggles, face mask, gloves, etc. as required

Workbench with vice

Welder

Angle grinder

Hacksaw, hammer, punch, chisel

Compasses, tape measure, angle gauge.

Spanners: 8,10,13,17,1 9mm : two of each.

Tap wrench and M1 0 taps for outer holes in magnet rotors.

Brass wire to gauge the heights of magnets

Pillar Drill Press

Drill bits 6,8,10,12mm

Holesaws 25mm, 65mm

Wood lathe, or a substitute as in Section 3 Chisel for wood lathe Jigsaw to cut wood

Scales to weigh resin. Dispenser for catalyst, plastic buckets, scissors.

Soldering iron, resin-cored solder, wire cutters, sharp knife.